Product Description
ATI TTR42 is a DOT special-permit, 42-gallon rectangle aluminum refueling tank built for legal, on-the-go refueling when installed and used per ATI guidance. Constructed from .125" diamond-plate aluminum, it’s fully baffled, pressure/leak-tested, and ships ready for your pump/cap setup.
Key Features
- 42-gallon capacity; built under a U.S. DOT special permit for refueling from the tank.
- .125" aluminum construction; fully baffled interior for stability.
- Two 2" NPT reinforced bungs for pump/cap placement flexibility.
- Vented filler cap (lockable vented cap available).
- Includes hold-down/mounting tabs; clean interior; pressure & leak tested.
- Approved for gasoline, diesel, kerosene, methanol, and aviation fuel (per permit).
Fitment
Universal pickup bed fit for most full-size truck beds. Low 12" overall height helps maintain rear visibility and bed usability. Always verify bed clearances before ordering.
Dimensions & Capacity
- Capacity: 42 gallons
- Overall length: ~48.5"
- Overall width: ~19"
- Overall height: ~12"
- Notes: Mounting tabs may add ~1.5" each side; fuel cap adds ~2.5" to total height—account for this when measuring.
What’s Included
- ATI TTR42 rectangle aluminum refueling tank
- Mounting/hold-down tabs
Pumps/hoses sold separately. Add a 12V transfer pump kit and a vented lockable cap for a complete setup.
Compliance
Manufactured in the USA and built under a U.S. DOT Special Permit authorizing refueling from the tank when properly installed and used.
Installation Notes
- Bolt through the welded tabs with appropriate hardware into the truck bed per ATI instructions.
- Plan your pump/cap side using the two 2" NPT bungs.
- Verify height including the ~2.5" cap and any bed-cover/toolbox clearances.
FAQ
- Is the TTR42 DOT approved for gasoline as well as diesel?
- Yes. Under ATI’s DOT special permit, the TTR42 is authorized for gasoline, diesel, kerosene, methanol, and aviation fuel. Always follow local regulations and ATI’s usage guidance.
- Does this tank include a pump?
- No. The tank ships with mounting tabs and a standard vented cap. Add a compatible 12V transfer pump/hoses as needed.
- What are the exact dimensions I should plan around?
- Plan for ~48.5" (L) x 19" (W) x 12" (H). Also allow ~1.5" per side for tabs and ~2.5" additional height for the cap.
- Is the interior baffled?
- Yes. The tank is fully baffled to reduce fuel movement and improve stability.
- Where can I place the transfer pump?
- Use either of the two reinforced 2" NPT bungs to locate your pump or filler cap on the preferred side.
