BANKS
BANKS 61301 3 PIN SENSOR EXTENSION CABLES
- SKU:
- BAN61301
- MPN:
- 61301
- Shipping:
- Calculated at Checkout
Related Products
Related Products
BANKS 61301-15 UNIVERSAL ANALOG EXTENSION PIGTAIL
BANKS
$14.00
Analog input pigtail harness for 4-Ch Analog Module. Used to wire your custom analog or resistance based sensor to the Banks 4-ch analog module. Contains 5V, Ground and Signal wire leads. Key...
BANKS 61301-36 AFTERMARKET ECU CABLE IDASH 1.8 (4 PIN)
BANKS
$38.00
Used to provide power to the iDash for vehicles without an OBD2 connection. (4pin) iDash 12V Power Cable. Used to power the iDash for use with Banks Sensor Modules in vehicles without OBD-II ...
BANKS 61301-25 B-BUS IN CAB EXTENSION CABLE (48 INCH) IDASH 1.8
BANKS
$22.00
Banks Bus in-cab extension cable 4 feet (48 in) long? Used to install gauges further apart. Example, install one gauge in A-pillar and one gauge in center console using the B-bus extension cable to...
BANKS 61301-24 B-BUS IN CAB EXTENSION CABLE (24 INCH) IDASH 1.8
BANKS
$20.00
Banks Bus in-cab extension cable 2 feet (24 in) long? Used to install gauges further apart. Example, install one gauge in A-pillar and one gauge in center console using the B-bus extension cable to...
BANKS 61301-18 FREQUENCY INPUT PIGTAIL 4-PIN MALE
BANKS
$24.00
Frequency input pigtail harness for 5-Ch Analog Module with frequency harness. 6 feet long. Used to wire your custom frequency sensor into Banks 5-ch analog with frequency module. Contains 12V, 5V,...
BANKS 61301-20 B-BUS STARTER CABLE IDASH 1.8
BANKS
$23.00
Banks Bus cable connects iDash 1.8 located inside the cab to Banks Modules located under the hood. Cable go through firewall. (6 pin female - 6 pin female circular twist lock) Enhance your vehicle's...
BANKS 61301-27 AFTERMARKET ECU TERMINATION CABLE IDASH 1.8
BANKS
$13.00
Banks Bus Termination cable for HW Rev 1 iDash and 12V Power Harness. Only one needed per network. Used to add a 120 ohm CAN termination resistor to the iDash 12V Universal Power Cable. (4 pin...
BANKS 61301-23 B-BUS IN CAB TERMINATOR CABLE (HW REV 1) IDASH 1.8
BANKS
$9.00
Banks Bus Termination cable for HW Rev 1 iDash only. Plugs into 6 pin port of iDash. Used to terminate iDash if using B-Bus modules or multiple iDash 1.8s. Only one needed per network. Enhance the...
BANKS 61301-22 B-BUS IN CAB Y-ADAPTER IDASH 1.8
BANKS
$17.00
Banks Bus Y-Adapter Cable. Used to daisy chain multiple iDash 1.8s. One Y-Adapter needed per additional iDash 1.8 gauge. (2x 6 pin female, 6 pin male) Enhance your diesel vehicle's monitoring...