RIDETECH 11527199 C2/C3 REAR STRONGARM SYSTEM FOR 1963-1979 CORVETTE OFFSET TRAILING ARMS SHOCK CROSS MEMBER STRUT RODS AND HARDWARE FOR USE W/ COIL-OVERS

Rear StrongArm system for 63-79 Corvette. Includes offset trailing arms, crossmembers, coil-over mounts and adjustable radius rods. Ridetech C2/C3 Rear StrongArm System. The rear suspension system utilizes an offset trailing arm W/ a trussed design which allows maximum tire width while providing the utmost in strength.

The rear trailing arm utilize a Teflon Bearing and the strut rods are outfitting W/ R-Joint rod ends to combine the best qualities of low friction movement, lateral stability, full range articulation, and quiet operation into one special bearing that is as home on the street as it is on the racetrack!

When combined W/ the tubular rear cross member the trailing arms place the coil overs to the rear of the axle for better motion ratio and damping control while providing additional height adjustment via the movable lower coil over mounts.

• Adjustable stance, 1-3 inch lower
• Mounting hardware to maintain ground and tire clearance, driveline angles, and load capacity
• Bolt-on installation (no fabrication required)
• Greatly improved handling performance
• Ultimate ride quality.
• For use W/ Ridetech Coil-Overs (sold separately)
• Suspension Location Rear
• Suspension Typeandnbsp;Coil-Over Suspension

The RIDETECH 11527199 C2/C3 Rear StrongArm System is a premier suspension upgrade designed specifically for 1963-1979 Corvettes. This cutting-edge system includes offset trailing arms, heavy-duty crossmembers, coil-over mounts, and adjustable radius rods, thus providing everything necessary to transform your Corvette’s rear suspension for both everyday driving and high-performance racing.

Built with a trussed design, the offset trailing arms maximize tire width while ensuring unparalleled strength and durability. This system employs advanced Teflon bearings that facilitate low friction movement alongside R-Joint rod ends. These sophisticated components ensure stellar lateral stability and full-range articulation, delivering quiet operation whether you’re cruising down the highway or tearing up the racetrack.

The tubular rear cross member configuration strategically positions the coil-overs behind the axle. This design not only enhances the motion ratio and improves damping control but also allows for additional height adjustments through movable lower coil-over mounts. With an adjustable stance that can lower your Corvette by 1 to 3 inches, this system helps maintain optimal ground clearance while providing enhanced driveline angles and load handling.

Installation is straightforward with a bolt-on process that requires no fabrication, making it accessible for both professional mechanics and DIY enthusiasts. The tremendous increase in handling performance and ride quality will leave a lasting impression, ensuring your Corvette performs at its very best.

Designed for compatibility with Ridetech Coil-Overs (sold separately), the Rear StrongArm System is the ultimate solution for C2/C3 owners looking to elevate their vehicle’s suspension capabilities. Experience the difference with RIDETECH’s dedication to performance and reliability.