Banks Bus in-cab extension cable 2 feet (24 in) long? Used to install gauges further apart. Example, install one gauge in A-pillar and one gauge in center console using the B-bus extension cable to...
CAN OBD-II cable for iDash (4 pin). Flat design for enhanced durability and cable routing under the dashboard or around trim pieces. Used to receive ECM data and power from vehicle's diagnostic port...
Banks Bus in-cab extension cable 4 feet (48 in) long? Used to install gauges further apart. Example, install one gauge in A-pillar and one gauge in center console using the B-bus extension cable to...
Banks Bus Termination Jumper for HW Rev 2 iDash only. Plugs into 2 pin terminal block on back of the iDash. Used to terminate iDash if using B-Bus modules or multiple iDash 1.8s. Only one needed per...
Banks Bus cable connects iDash 1.8 located inside the cab to Banks Modules located under the hood. Cable go through firewall. (6 pin female - 6 pin female circular twist lock) Enhance your vehicle's...
Banks Bus Termination cable for HW Rev 1 iDash only. Plugs into 6 pin port of iDash. Used to terminate iDash if using B-Bus modules or multiple iDash 1.8s. Only one needed per network. Enhance the...
Upgrade and control your PedalMonster. Display 2-8 values including up to 80 OBDII Mode 01 values with over 300 parameters available. View Data your dash does not display and accurate values your OEM...
Upgrade and control your PedalMonster. Display 2-8 values with over 300 parameters available, including up to 80 OBDII Mode 01 values. View Data your OEM dash does not display and accurate values...